The Magnus hook connector is used to create node joints in timber-frame construction. This joint is impressive above all because it can be completely prefabricated, which in turn minimises assembly times on the construction site. The connector consists of two different components, as well as wood construction screws and fixing screws. The two separate parts of Magnus are attached to the respective structural members using the wood construction screws and then slotted into one another smoothly without the need to apply force. The two components are braced against one another using fixing screws. This provides effective prevention against the joint being loosened inadvertently. With high verified load values, joints created by the Magnus can be statically loaded in five directions. Installation can be both visible (for shadow-groove connections) and hidden (milled in).

Installation instructions

Hidden (milled-in) main/secondary beam joints

1. Adjust the end stop of the milling and assembly jig to the desired size of the Magnus hook connector, apply and screw on the milling and assembly jig, and create a routed slot with the corresponding groove-milling cutter.

2. The Magnus is then inserted into the routed slot and fastened in place using the supplied system screws. Following this, the milling and assembly jig is placed in the same position as before on the component that is to be connected, and the second part of the Magnus hook connector is screwed on. Pre-assembly is now complete, and the component being connected is hooked in place.

3. The fixing screws are then inserted into the Magnus. This pulls the Magnus hook connector together, if necessary, and ensures correct positioning of the node joint.