KonstruX Timber Construction Screws Fully Threaded with a Cylinder Head and Zinc Plated. High strength fully threaded screws up to 1000mm long. These screws simultaneously provide a high pull-out resistance and help maintain a strong connection, and the advantage of its new drill tip ensures a reduced screw in torque.
These construction screws are used during timber frame engineering and a user friendly ECS calculation software package can be downloaded free of charge. The following software allows pre-calculations of main and secondary beam connections, joist doubling and reinforcements of supports. This is also a verifiable calculation aid in accordance with EN 1995 (Eurocode 5) and DIN 1052.
ETA 11/0024 approved.
Available to buy online at Swiftfix here.
One system for all load-bearing connections in timber construction
- For application especially in timber engineering, carpentry, timber frame construction, hall construction, timber element construction, renovation of floor ceilings, etc.
- Also ensures the highest power transmission.
- The fully-threaded screws maximise the load-bearing capacity of a connection due to the high threaded pull-out resistance in both components. When using partial threaded screws, the significantly lower head pull-through resistance in the attachment part limits the load-bearing capacity of the connection.
- They are a time and cost-saving alternative to traditional connections or timber joints such as joist hangers, joist supports, etc.
- Additionally, wood has a low transverse pressure and transverse tensile strength. Hence for reinforcement, the screws are placed in the wood, to “take over” a large part of the forces.
- Doubling up of joists, for example, increases the load-bearing capacity of floor joists and reduces bending. These fully threaded screws subsequently join the components together in a displacement-resistant manner.
- Additionally they have invisible connections, a high fire resistance, and no thermal bridges.
- There is no pre-drilling required after approval/ETA. From screw lengths ≥ 245 mm, however, a trend-setting pre-drilling to 1/3 of the screw length can be recommended (no running of the screw).
- Further in the case of screws that are used exclusively on tension, the required edge and axle distances may be minimised.





For more information on these products, please contact our Swiftfix team.